RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-84
RDFCOM Messages
Cause. You added a receiver with the specified ATINDEX, but there is no extractor
with that value.
Effect. The validation fails.
Recovery. Add an extractor with the same ATINDEX value or delete the particular
receiver.
Cause. You added an extractor with the specified ATINDEX, but there is no receiver
with that value.
Effect. The validation fails.
Recovery. Add a receiver with the same ATINDEX value or delete the particular
extractor.
Cause. You added an extractor and receiver with the specified ATINDEX, but there are
no updaters with that value.
Effect. The validation fails.
Recovery. Add at least one updater with the same ATINDEX value or delete the
particular extractor-receiver pair.
volume-name
is the name of the image trail’s volume
subvolume-name
is the name of the image trail’s subvolume.
Cause. The COPYAUDIT command could not find any image files on the remote image
trail. This problem indicates that the receiver’s RETAINCOUNT value was probably
not set high enough and that, as a result, some image files on the remote system were
purged.
Effect. The COPYAUDIT command aborts.
No EXTRACTOR is configured for ATINDEX atindex
No RECEIVER is configured for ATINDEX atindex
No VOLUMES are configured for ATINDEX atindex
No image files could be found in the imagetrail on volume-
name.subvolume-name