RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual522204-001
C-92
RDFCOM Messages
error#
is the error number that identifies the specific error.
progfile
is the name of the program file on which the error was encountered.
Cause. A NEWPROCESS error occurred during START RDF or TAKEOVER
processing.
Effect. The START RDF or TAKEOVER operation is aborted.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting process errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system manager.
Cause. The operator issued a TAKEOVER command at the backup node while RDF
was performing a TAKEOVER operation.
Effect. The last TAKEOVER command is ignored.
Recovery. This is an informational message; no recovery is required.
Cause. The RDF configuration file is invalid.
Effect. The attempt to add the RDF configuration record fails.
Recovery. Specify a valid device name.
Program File Error: error# on progfile
RDF already in TAKEOVER processing
RDF BACKUPSWAP device is NOT a disk volume