RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-93
RDFCOM Messages
volume-name
is the name of the swap file on which the error was encountered.
Cause. The RDF configuration file is invalid.
Effect. The attempt to add the RDF configuration record fails.
Recovery. Specify a valid volume name.
Cause. The configuration file must be open before any RDFCOM commands other than
OPEN or OBEY can be executed.
Effect. The attempted operation is aborted.
Recovery. Open the configuration file with the OPEN command.
Cause. You issued an INITIALIZE RDF command, but entered NO or N in response to
the subsequent confirmation prompt for continuing the initialization process.
Effect. RDF is not initialized.
Recovery. This is an informational message; no recovery is required.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause. Your are attempting to validate the network master of your RDF network before
you have validated all non network master subsystems.
Effect. Validation fails.
Recovery. Validate all your non network master subsystems and then validate your
local subsystem.
RDF BACKUPSWAP volume-name does NOT exist
RDF configuration file is not open, use OPEN command
RDF has not been initialized.
RDF network subsystem ctrl-subvol has not been validated