RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-94
RDFCOM Messages
Cause. A STATUS RDF or STOP RDF command was issued while RDF was stopped.
Effect. The command fails.
Recovery. Reissue the command after RDF is started.
filename
is the name of the non-existent EMS collector (RDF log file).
node
is the name of the system where the collector name is invalid.
Cause. The RDF configuration file is invalid: a non-existent EMS collector was
specified.
Effect. The ADD RDF command fails.
Recovery. Specify a valid EMS collector name in a SET RDF command, and then
reenter the ADD RDF command.
dev-name
is the name of the device in question.
Cause. The RDF configuration file is invalid: the specified device for the RDF swap
file on the primary node is not a disk volume.
Effect. The ADD RDF command fails.
Recovery. Specify a valid device name in a SET RDF command, and then reenter the
ADD RDF command.
RDF (\primary -> \backup) is NOT running
RDF LOGFILE filename NOT a legal filename on system \node
RDF PRIMARYSWAP dev-name is NOT a disk volume