RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-96
RDFCOM Messages
Cause. A START RDF command failed. RDF writes a description of the problem in
the LOGFILE.
Effect. The START RDF command fails.
Recovery. Check the EMS event log for the message covering this error. If possible,
correct the cause of the error and reissue the START RDF command. Otherwise, contact
your system manager.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause. The RDF subsystem that you specified as your network master has not been
configured as a network master.
Effect. Validation fails.
Recovery. You need to reconfigure your local subsystem and specify the control
subvolume of your network master. You may also need to reconfigure your network
master.
Cause. RDFCOM detected an internal error in handling your response to the RDFCOM
prompt.
Effect. The attempted command is aborted.
Recovery. Contact the Compaq Global Customer Support Center (CGSC) or your
service provider.
Cause. In response to a prompt, you requested RDFCOM to trigger restoration of an
audit trail file. If the file has been previously dumped to tape, you must now watch the
EMS log for the TMP’s prompt to mount the appropriate tape.
Effect. The restore operation proceeds.
Recovery. When the tape-mount prompt appears in the EMS log, mount the tape.
RDF START Failure, Scan LOGFILE for reason
RDF subsystem ctrl-subvol is not confgured as a Network
master
RDFCOM internal error in handling prompt
RDFCOM is asking the TMP to restore the file. If the file
was previously dumped to tape, watch for the TMP to tell you
to mount the appropriate tape.