RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-98
RDFCOM Messages
error#
is the file-system error number that identifies the specific error.
Cause. The COPYAUDIT command encountered the specified error while attempting
to read data from a remote image file on the remote image trail.
Effect. The COPYAUDIT command aborts.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the COPYAUDIT command. Otherwise, see your system manager.
device
is the name of the non-disk device.
Cause. The RDF configuration file is invalid.
Effect. The validation of the receiver fails.
Recovery. Specify a valid disk volume.
error#
is a file-system error number that indicates lack of storage space on disk.
Cause. During execution of a START RDF command, RDFCOM determined that
sufficient disk storage for image files did not exist.
As one of its validation checks during START RDF processing, RDFCOM tries to create
a temporary image file on the receiver’s RDFVOLUME and then to allocate all 16
extents. This check, if successful, verifies that:
•
If RDF is starting for the first time, there is enough storage for at least one image file
•
If RDF has been started previously, there is enough storage for one image file when
the next image-file rollover occurs
If the check fails because there is insufficient storage, this message appears.
Effect. The START RDF command is aborted.
Read error error# on remote image file
RECEIVER RDFVOLUME device is NOT a disk volume
RECEIVER RDFVOL error error# on allocation