RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-99
RDFCOM Messages
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. Make sufficient space available on
disk, and then reenter the START RDF command.
error#
is the file-system error number that identifies the specific error.
Cause. During execution of a START RDF command or a VALIDATE
CONFIGURATION command, RDFCOM determined that sufficient disk storage for
image files did not exist on the RDFVOLUME. As one of its validation checks during
processing of these commands, RDFCOM tries to create a temporary image file on the
receiver’s RDFVOLUME and then to allocate all 16 extents. This check, if successful,
verifies that:
•
If RDF is starting for the first time, there is enough storage for at least one image file
•
If RDF has been started previously, there is enough storage for one image file when
the next image-file rollover occurs
If the check fails because there is insufficient storage, this message appears.
Effect. The command fails.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system manager.
volume-name
is the name of the non-existent RDFVOLUME file.
Cause. The RDF configuration file is invalid.
Effect. The validation of the receiver fails.
Recovery. Specify a valid disk volume.
RECEIVER RDFVOL error error# on creation
RECEIVER RDFVOLUME volume-name does NOT exist