RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-100
RDFCOM Messages
Cause. You tried to add a secondary image trail before adding the receiver’s
configuration record.
Effect. The command fails.
Recovery. Add the receiver’s record. Then, add the secondary image trail.
Cause. An ADD RECEIVER command was issued when the configuration file already
contained a receiver record.
Effect. The command fails.
Recovery. No recovery is required if you want to use the existing receiver process as it
is configured. If you want to change any of the receiver’s configuration options,
however, enter an ALTER RECEIVER command that specifies those changes.
Cause. The INFO command could not find a receiver record in the configuration file.
Effect. The command fails.
Recovery. Alter the configuration to include a receiver process.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause. RDFCOM was unable to read the receiver record for the RDF subsystem with
the specified control subvolume.
Effect. Validation fails.
Recovery. Determine why the receiver record for the subsystem cannot be obtained.
RECEIVER Record does not exist
RECEIVER record exists, use ALTER RECEIVER
RECEIVER record NOT found.
Receiver record not found for subsystem ctrl-subvol.