RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-104
RDFCOM Messages
Cause. RDFCOM is unable to reach the specified backup system.
Effect. The configuration command fails.
Recovery. Determine why the communications path to this system is down and take the
appropriate recovery steps to bring it back up.
Cause. The specified primary system does not exist.
Effect. The configuration command fails.
Recovery. You must specify a valid primary system name.
Cause. RDFCOM is unable to reach the specified primary system.
Effect. The configuration command fails.
Recovery. Determine why the comm path to this system is down and take the
appropriate recovery steps to bring it up.
timestamp
is the shutdown timestamp to which the initialization was requested.
Cause. RDFCOM has searched the entire MAT currently on disk, but the timestamp
you specified in the INITIALIZE RDF command is earlier than the earliest audit
timestamp in the audit trail
Effect. RDF is not initialized.
Recovery. If all files of the MAT are currently on disk (for instance, the files from
AA000001 to the current audit file), then the specified timestamp is earlier than the last
time TMF was initialized. To recover, you need to reexamine the EMS log or the
OPRLOG for a later TMF shutdown point or stop TMF and use that shutdown point.
Specified network backup system <name> is unavailable.
Specified network primary system <name> is not defined.
Specified network primary system <name> is unavailable.
Specified TMF shutdown timestamp at timestamp is earlier than
the earliest timestamp in the TMF MAT. Please examine the
OPRLOG for a correct TMF shutdown timestamp.