RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Messages
Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001
C-126
RDFCOM Messages
Recovery. Performing the takeover might still leave the database inconsistent. If you
nevertheless choose to perform the takeover operation, you must first manually repair
the last image file on disk. Before proceeding, contact the Compaq Global Customer
Support Center (CGSC) or your service provider.
Cause. You tried to issue a critical RDFCOM command, but you are not the super-user
who initialized the RDF configuration.
Effect. The command fails.
Recovery. Log on as the super-user who initialized your RDF configuration.
Cause. The current limit for the number of RDF subsystems in your RDF network is 48
and you have attempted to add 49.
Effect. The configuration command fails.
Recovery. Do not add any more network records.
Cause. You tried to start RDF after an RDF takeover operation has been performed.
Effect. The START RDF command fails.
Recovery. You must initialize RDF on the primary system. You should also ensure that
the takeover operation completed successfully.
Cause. You tried to start updaters by either a START RDF or START UPDATE
command before the extractor completed Phase 2 of its database synchronization
operation.
Effect. The START RDF or START UPDATE command fails.
Recovery. You must wait until the extractor has logged message 782 before starting the
updaters. You can, however, issue a START RDF, UPDATE OFF command.
You are logged on as <user-id>.
To issue this command you must be <super-user>.
You cannot add more than 48 network records
You cannot START RDF after an RDF Takeover operation.
You cannot start updaters before the extractor has completed
Phase 2 of its online database synchronization operation.