RDF/IMP and IMPX System Management Manual (RDF 1.3+)

Installing and Configuring RDF

Compaq NonStop™ RDF/IMP and IMPX System Management Manual—522204-001

3-29

Enabling RDF Operations

After you have copied all pertinent database files from the primary system to the backup

system, installed the RDF software on both systems, initialized and configured TMF on

the primary and all backup systems, and initialized and configured RDF, you can then

start the TMF and RDF subsystems. You must start TMF on the primary and all backup

systems before you can start RDF.

Starting TMF

To start or restart TMF, issue the TMFCOM command START TMF. If you plan to start

the applications being protected by TMF before starting RDF, you can include the

DISABLE BEGINTRANS option in the START TMF command; this option prevents

the applications from starting any transactions until you issue the TMFCOM command

ENABLE BEGINTRANS. For details about these TMFCOM commands, see the

NonStop™ TM/MP Reference Manual.

Starting RDF

To start RDF, issue the RDFCOM command START RDF, as follows:

]START RDF

Notice that to issue this command, you must have an RDFCOM session running and

meet all of the following requirements:

•

Be logged on as a member of the super-user group

•

Have remote passwords on both the primary and backup systems

•

Ensure that the RDF configuration file contains all necessary parameters

•

Ensure that all updater volumes on the backup system are enabled for transaction

processing

When RDF starts execution, it automatically performs a validation check on the

configuration file; if the check succeeds, RDF copies the configuration file

$SYSTEM.control-subvolume.CONFIG to the backup system.

If the RDF configuration file does not exist, or if there are any missing or invalid

parameters, RDFCOM displays an error message and aborts the start operation.

If you did not start TMF on the backup system, or if you did not add an updater volume

to the TMF configuration on the backup system and enable it for transaction processing,

the corresponding updater logs an RDF error and terminates immediately. If you started

TMF on the backup system and added the updater volume to the TMF configuration but

did not enable that volume for transaction processing, the updater issues an error

message and then stops.

If TMF BEGINTRANS is disabled, RDF issues an error message.