RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Operating and Monitoring RDF
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
4-13
Running RDFSCAN
Help for RDF Error Messages
For information about a particular error message (its cause, effect, and recommended
recovery steps), enter HELP followed by the message number. For example, to obtain
information about message #715, enter:
]HELP 715
In response, RDFCOM displays the following information:
-------------------------------------------------------------
| 715 Primary Stopped |
-------------------------------------------------------------
Cause: The primary process of a NonStop process pair
has stopped. This probably was the result of an
operator inadvertently issuing a STOP command
from TACL.
Effect: The backup process takes over, but not in
fault-tolerant mode, until the primary process
can be re-created.
Recovery: This is an informational message; no recovery
is required.
Running RDFSCAN
RDFSCAN is an interactive command interpreter through which you begin a session
and enter requests to scan and display the content of intermediate entry-sequenced
RDF message file produced by the standard EMS filter RDFFLTO. RDFSCAN runs
under the Guardian user interface (normally TACL) to the operating system. To begin
an RDFSCAN session and enter commands interactively, enter the keyword
RDFSCAN at the current TACL prompt.
Command Syntax for Starting an RDFSCAN Session
To enter an RDFSCAN session, use the following command syntax:
RDFSCAN
is an implicit RUN command, instructing the TACL command interpreter to run the
RDFSCAN utility program.
filename
specifies the entry-sequenced file to be opened.
RDFSCAN filename