RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Operating and Monitoring RDF
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
4-18
Displaying Current Configuration Parameters and
Operating Statistics
Displaying Current Configuration Parameters and Operating
Statistics
While RDF is running, you can obtain current configuration information and operating
statistics for the RDF environment by using ASAP (see Appendix E, Using ASAP) or by
using the RDFCOM utility. To display this information using the RDFCOM utility, enter
the STATUS RDF command as follows:
]STATUS RDF
In response, RDF displays the following:
RDFCOM - T0346A04 - 09DEC02
(C)1988 Tandem (C)2003 Hewlett Packard Development Company, L.P.
Status of \RDF04 -> \RDF05 RDF 2000/03/14 14:08:19.072
Control Subvol: $SYSTEM.RDF04
Current State : Normal
RDF Process Name RTD Time Pri Volume Seqnce RByte Addr Cpus Error
------------------ ----- --------- --- ------- ------ ---------- ----- -----
Monitor $RMOR 185 $AUDIT 56 1: 2
Extractor (0) $RE01 0:00 185 $AUDIT 56 928000 1: 2
Extractor (1) $RE02 0:00 185 $DATA17 4 10435580 1: 2
Receiver (0) $RR01 0:00 185 $DATA01 44 1: 2
Receiver (1) $RR02 0:00 185 $DATA02 3 1: 2
Imagetrail (0) $DATA03 22
Imagetrail (1) $DATA04 3
Purger $RPRG 185 1: 2
RDFNET $MNET 165 0: 2
$DATA06 -> $DATA06 $RU01 0:06 185 $DATA03 20 749568 1: 2
$DATA07 -> $DATA07 $RU02 0:00 185 $DATA04 3 811008 2: 3
$DATA08 -> $DATA08 $RU03 0:06 185 $DATA04 3 749568 3: 0
STATUS RDF Display
In the STATUS RDF display, the first line gives the name of the primary system
(\RDF04 in this example), the name of the backup system (\RDF05 in this example),
and the timestamp that shows when the STATUS RDF command was issued. The
second line specifies the fully-qualified name of the control subvolume. The third line
specifies the current state of the subsystem; any of the following entries are possible:
•
Normal
•
Normal - Update Stopped
•
Start Update Pending
•
Stop Update Pending
•
Stop Update, Timestamp Pending
•
* STOP RDF In Progress *