RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Managing RDF

HP NonStop RDF/IMP and IMPX System Management Manual—524388-001

5-4

Recovering From File System Errors

Table 5-3 lists the file system error numbers and recovery actions for RDF event 739,

which reports file-creation failures.

130 through 139 Repair the device or clear the condition.

157 Check file integrity.

190 Repair the device or clear the condition.

199 Alter the security (probably Safeguard).

200 through 231 Repair the device or clear the condition.

Table 5-3. Recovery From File Creation Failures (RDF Event 739)

File System Error Recovery Action

10 The file already exists. Purge the old one.

14 Repair the device or clear the condition.

30 through 37 If the problem persists, alter the hardware configuration or perform

system tuning.

43 through 45 Provide more room for the file or extent by using FUP commands,

such as PURGE and ALTER MAXEXTENTS, or by compressing files.

You might need to issue a STOP UPDATE command.

48 Alter the security (probably Safeguard). If an updater fails to create a

data file on a backup volume because of a security violation, it logs

this error and restarts with this file-creation image until you change the

security.

50 through 58 Repair the device or clear the condition.

59 Check file integrity.

60 through 66 Repair the device or clear the condition.

100 Repair the device or clear the condition.

103 Repair the device or clear the condition.