RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Entering RDFCOM Commands
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
8-28
Command Overview
To display information about RDF message #715, enter:
]HELP 715
RDFCOM displays the following description:
-------------------------------------------------------------
| 715 Primary Stopped |
-------------------------------------------------------------
Cause: The primary process of a NonStop process pair
has stopped. This probably was the result of an
operator inadvertently issuing a STOP command
from TACL.
Effect: The backup process takes over, but not in
fault-tolerant mode, until the primary process
can be re-created.
Recovery: This is an informational message; no recovery
is required.