RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Entering RDFCOM Commands
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
8-30
Command Overview
INFO
The INFO command displays the current configuration parameter values from the
configuration file for the specified process or other object.
*
displays the current configuration parameter values for the RDF global options, for
all updater volumes, and for all RDF processes.
[ATINDEX audittrail-index-num]
is an integer value from 0 through 15 identifying the TMF audit trail on the primary
system with which the particular RDF object is associated. 0 specifies the MAT. 1
through 15 specify auxiliary audit trails AUX01 through AUX15, respectively.
Note that you can use this option only with the EXTRACTOR, IMAGETRAIL,
RECEIVER, and [VOLUME] $volume variations of the INFO command.
For INFO EXTRACTOR, INFO IMAGETRAIL, and INFO RECEIVER commands,
the default is 0. If you omit this parameter, RDFCOM assumes you want to display
information about the designated object associated with the MAT.
For INFO VOLUME commands, this parameter is optional regardless of whether
the updater is associated with MAT or an auxiliary audit trail.
OBEYFORM
formats the INFO command output as command file text that can be executed by
RDFCOM. Before issuing the INFO command, you can designate the command
file for this text by specifying the file name in either:
•
The OUT option of the RDFCOM command that begins your interactive
session
•
An OUT command issued during the session
If you do not specify a command file for the text, TACL supplies the name of its
current default output destination—usually the terminal from which you began your
session.
INFO {* } [ATINDEX audittrail-index-num]
{IMAGETRAIL } [,OBEYFORM]
{RDF }
{MONITOR }
{EXTRACTOR }
{RECEIVER }
{RDFNET }
{NETWORK }
{PURGER }
{VOLUME * }
{[VOLUME] $volume }