RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Entering RDFCOM Commands
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
8-59
Command Overview
SET NETWORK
The SET NETWORK command sets RDF network configuration parameters within the
RDF configuration memory table. The supplied values are not applied to the RDF
configuration file, however, until you issue an ADD NETWORK command.
PRIMARYSYSTEM primary-system
for a network master, specifies the name of the primary system.
for a non network master, specifies the name of the network master’s primary
system.
BACKUPSYSTEM backup-system
for a network master, specifies the name of the associated backup system.
for a non network master, specifies the name of the network master’s backup
system.
REMOTECONTROLSUBVOLUME subvolume
for a network master, specifies the name of the primary system’s remote control
subvolume.
for a non network master, specifies the name of the network master’s remote
control subvolume.
PNETTXVOLUME $volume
for a network master, specifies the name of the primary system volume on which
the RDF subsystem stores an audited network synchronization file.
Where Issued
Primary system only.
Security Restrictions
You can issue the SET NETWORK command only if you are a member of the super-
user group.
SET NETWORK network-option
where network-option is:
{PRIMARYSYSTEM primary-system }
{BACKUPSYSTEM backup-system }
{REMOTECONTROLSUBVOLUME subvolume }
{PNETTXVOLUME $volume }