RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Entering RDFCOM Commands
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
8-67
Command Overview
When set to OFF (the default value), Enscribe purge operations are not replicated.
You should use the default (OFF) for all RDF configurations (unless you have a
specific need for replicating Enscribe purge operations).
If you configure the RDF subsystem to replicate network transactions, you should
not replicate Enscribe purge operations because doing so might result in
unexpected errors during the updater network undo processing.
When set to ON, Enscribe purge operations on the primary system are replicated
on the backup system.
Where Issued
Primary system only.
Security Restrictions
You can issue the SET RDF command only if you are a member of the super-user
group.
RDF State Requirement
You can only enter the SET RDF command for global configuration parameters if you
have not already used the ADD RDF command to apply the parameter values to the
RDF configuration file. For further information, see the ADD command description.
Usage Guidelines
The SET RDF command enters the global parameter values specified in this command
into the RDF configuration table in memory. This table serves as an input buffer only,
and so these values do not affect the subsystem until they are applied to the RDF
configuration file with the ADD command.