RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Entering RDFCOM Commands
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
8-82
Command Overview
SHOW NETWORK Command
Suppose that a series of SET NETWORK commands specifies \RDF04 as the network
master’s primary system, \RDF06 as the network master’s backup system, RDF04 as
the network master’s remote control subvolume, and $DATA07 as the network
master’s PNETTXVOLUME volume.
To display the values specified by those SET NETWORK commands, enter:
]SHOW NETWORK
RDF displays the following:
NETWORK PRIMARYSYSTEM \RDF04
NETWORK BACKUPSYSTEM \RDF06
NETWORK RCSV RDF04
NETWORK PNETTXVOLUME $DATA07