RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Entering RDFCOM Commands
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
8-87
Command Overview
PERIOD seconds
specifies the interval in seconds between successive executions of the command.
COUNT repeat
specifies how many times to execute the particular STATUS command. If you omit
the COUNT repeat option but include the PERIOD seconds option, the command
is executed repeatedly at the specified time intervals until you press the BREAK
key.
Where Issued
Primary or backup system.
Security Restrictions
None; anyone can enter a STATUS command.
RDF State Requirement
You can enter a STATUS command at any time after RDF has been initialized.
Usage Guidelines
The STATUS command provides you with the most current information about RDF and
its operational status, presenting data for the specified RDF processes.
STATUS RDF Command Output Display
The STATUS RDF command presents its display in the following format:
RDFCOM - T0346A04 - 19DEC02
(C)1988 Tandem (C)2003 Hewlett Packard Development Company, L.P.
Status of \RDF04 -> \RDF05 RDF 2003/03/14 14:08:19.072
Control Subvol: $SYSTEM.RDF04
Current State : Normal
RDF Process Name RTD Time Pri Volume Seqnce RByte Addr Cpus Error
------------------ ----- --------- --- ------- ------ ---------- ----- -----
Monitor $RMOR 185 $AUDIT 56 1: 2
Extractor (0) $RE01 0:00 185 $AUDIT 56 928000 1: 2
Extractor (1) $RE02 0:00 185 $DATA17 4 10435580 1: 2
Receiver (0) $RR01 0:00 185 $DATA01 44 1: 2
Receiver (1) $RR02 0:00 185 $DATA02 3 1: 2
Imagetrail (0) $DATA03 22
Imagetrail (1) $DATA04 3
Purger $RPRG 185 1: 2
RDFNET $MNET 165 0: 2
$DATA06 -> $DATA06 $RU01 0:06 185 $DATA03 20 749568 1: 2
$DATA07 -> $DATA07 $RU02 0:00 185 $DATA04 3 811008 2: 3
$DATA08 -> $DATA08 $RU03 0:06 185 $DATA04 3 749568 3: 0