RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Entering RDFCOM Commands
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
8-104
Command Overview
•
All necessary RDF image files are present (for an RDF restart).
•
The volumes for the image files (specified by the RDFVOLUME option of a SET
RECEIVER command and any ADD IMAGETRAIL commands) are valid and exist
on the backup system.
•
The volumes for the image files have enough room for two more image files (for an
RDF restart).
•
The primary volumes associated with the updater processes are valid and are
being audited to the TMF audit trail.
•
The backup volume associated with each updater process (specified by the
UPDATEVOLUME option of the SET VOLUME command) exists on the backup
system.
If RDFCOM detects any configuration errors, it displays an appropriate message.
Example
To validate the RDF configuration, enter:
]VALIDATE CONFIGURATION
If the current content of the RDF configuration file is valid, RDFCOM displays the
following message:
Configuration Validated
If any of the parameters in the RDF configuration file are not valid, RDFCOM displays
a message such as the following:
BACKUPSYSTEM (\TORONTO) is not available
RECEIVER RDFVOLUME $TRAIN does not exist