RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Network Transactions
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
13-3
Network Configuration Record
If you are configuring the network master RDF subsystem, you must include a network
configuration record for every RDF subsystem in the RDF network (including the
network master itself). Each of those records must include the following attributes:
If you are configuring a non network master RDF subsystem, you must include a single
network configuration record containing the following attributes:
Thus, within its configuration file, the network master has all necessary information
about every system in the RDF network (whereas the other systems have only a
pointer enabling them to obtain information about other systems in the network).
PRIMARYSYSTEM Network Attribute
This is the name of a primary system. It is set by the following RDFCOM command:
SET NETWORK PRIMARYSYSTEM system-name
There is no default value. Each primary system within an RDF network must be
unique within the network. An RDF network cannot contain two or more RDF
subsystems with the same primary system (that is, it cannot contain RDF subsystems
for \A to \B and \A to \C).
BACKUPSYSTEM Network Attribute
This is the name of the backup system associated with the specified primary system. It
is set by the following RDFCOM command:
SET NETWORK BACKUPSYSTEM system-name
There is no default value.
PRIMARYSYSTEM system-name Name of the primary system.
BACKUPSYSTEM system-name Name of the associated backup system.
REMOTECONTROLSUBVOL
subvolume-name
Name of the primary system’s remote control
subvolume.
PNETTXVOLUME volume-name Name of the primary system volume on which
the RDF subsystem stores an audited network
synchronization file.
PRIMARYSYSTEM system-name Name of the network master’s primary system.
BACKUPSYSTEM system-name Name of the network master’s backup system.
REMOTECONTROLSUBVOL
subvolume-name
Name of the network master’s remote control
subvolume.