RDF/IMP and IMPX System Management Manual (RDF 1.4+)

HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
A-1
A RDF Command Summary
The syntax rules for the RDFCOM and RDFSCAN commands, explained in detail in
Section 8, Entering RDFCOM Commands and Section 9, Entering RDFSCAN
Commands respectively, are summarized in this appendix. This section, which is
directed to system managers and operators, summarizes the syntax descriptions for:
•
The command to run RDFCOM from the Guardian user interface to the HP
NonStop Kernel operating system
•
The RDFCOM commands, listed in alphabetical order, beginning with the
ADD command
•
The command to run RDFSCAN from the Guardian user interface to the NonStop
Kernel operating system
•
The RDFSCAN commands, listed in alphabetical order, beginning with the
AT command
•
The file names and process identifiers that are common parameters in many
RDFCOM and RDFSCAN commands
Command to Run RDFCOM
RDFCOM runs under the Guardian user interface (normally the TACL command
interpreter) to the NonStop™ Kernel operating system. The RDFCOM command starts
a session that lets you enter RDFCOM commands interactively, noninteractively, or
through a command file.
Where issued: primary or backup system.
Security: Any user.
RDFCOM [/[IN command-file ] [,OUT output-file ]/ ]
[control-subvolume] ; [command [; command ]...]