RDF/IMP and IMPX System Management Manual (RDF 1.4+)

RDF Command Summary
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
A-14
RDFSCAN Commands
RDFSCAN Commands
Command to Run RDFSCAN
RDFSCAN runs under the Guardian user interface (normally the TACL command
interpreter) to the NonStop™ Kernel operating system. The RDFSCAN command
starts an RDFSCAN session that lets you enter RDFSCAN commands interactively,
noninteractively, or through a command file.
Where issued: primary or backup system.
Security: Any user.
AT
The AT command specifies the record in the RDF log file at which RDFSCAN begins
the next operation.
DISPLAY
The DISPLAY command enables or disables the display of line (record) numbers in
subsequent RDFSCAN output.
EXIT
The EXIT command ends your current RDFSCAN session.
FILE
The FILE command selects the RDF log file to which subsequent RDFSCAN
commands apply.
RDFSCAN [ file ]
AT [record-number]
DISPLAY {ON | OFF}
EXIT
FILE [\system.][$volume.][subvolume.]file