RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-4
RDF Messages
703
Cause. The updater has sent a request for permission to read the undo list, but the
purger has not yet given the updater permission.
Effect. The updater waits until the purger has completed building the undo list.
Recovery. This is an informational message; no recovery is required, unless the
purger is reporting problems.
704
Cause. The purger has detected that all the updaters have stopped, but at least one
updater stopped prematurely and did not stop at the specified timestamp.
Effect. The updaters are stopped, but the backup database is not in a consistent state
corresponding to the stop update timestamp.
Recovery. Restart the updaters. If you still need to bring the backup database to a
consistent state, do as follows. Wait for the updaters to catch up and then issue a new
stop-update-to-time command, specifying a new timestamp.
705
error#
is the file-system error number that identifies the specific error.
name
is the name of the file or process that was to be opened.
Cause. A file-system error occurred while RDF was attempting to open a file or
process.
Effect. Variable; depends upon which file-system error occurred and which file or
process was to be opened. If this error is issued by a process other than an updater
against any file other than the EMS event log, then RDF will shut down, except in the
following cases:
•
The extractor retries OPEN calls for the audit trail files if file-system error 11
(file missing), 12 (file in use), or 59 (file is bad) occurs. Those errors might occur
while the audit trail file is being restored to disk. The extractor retries the OPEN
Still waiting on purger for undo pass.
Updaters stopped before stop-update-to-time has completed.
File Open Error error# on name