RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-5
RDF Messages
operation indefinitely, and will respond to RDFCOM commands while the retries
are taking place.
•
The receiver retries OPEN calls for the image files if file-system error 11 (file
missing), 12 (file in use), or 59 (file is bad) occurs. Those errors might occur while
the image file is being restored to disk.
Recovery. If this message is issued by an updater process, consult Table 5-1 to
determine the appropriate recovery actions.
706
Cause. The monitor process has stopped itself and all RDF processing as the result of
an operator-initiated stop or a catastrophic failure.
Effect. The monitor sends a stop message to all RDF processes, and they all
successfully shut down.
Recovery. If the operator issued a STOP TMF or STOP RDF command, this message
is merely informational and no recovery is required.
If this message is unexpected, check the EMS event log to determine the cause of the
failure.
You can attempt to correct the underlying problem, and then restart RDF. If you do
that, however, you should select a convenient time at which to stop TMF and verify that
the primary and backup databases are synchronized.
You should also consult the EMS event log to determine whether the shutdown and
startup proceeded without error. If that is not the case, no recovery is possible.
707
Cause. The extractor detected that TMF has not been started.
Effect. RDF cannot run if TMF is not also running. Normally, RDFCOM will discover
that TMF has not been started and will prevent RDF from starting. In the case of RDF
event 707, TMF was running when RDFCOM verified that TMF was started, but TMF
Note. If the extractor detects that the OPEN operation failed because the audit trail had
been purged, it logs RDF Error 839 (Audit trail file is missing) rather than Error 705,
prompting you to restore the audit trail file.
RDF Monitor Shutdown Complete
Note. If TMF dumps any audit trail files to disk while RDF is stopped, you must either restore
the dumped files to disk or resynchronize the primary and backup databases before restarting
RDF.
TMF is not yet started