RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-6
RDF Messages
was then stopped before the extractor was started. If the extractor detects that TMF is
not started, the extractor aborts itself, and the monitor aborts the receiver and itself.
Recovery. Start TMF before trying to start RDF.
708
Cause. An internal error has been detected in RDFCOM.
Effect. RDFCOM aborts.
Recovery. This is an internal error. Contact your service provider.
709
filename
is the name of the new EMS event log (collector).
Cause. An RDF process has successfully changed the logfile to the specified EMS
Event Collector.
Effect. Messages are now logged to the new collector.
Recovery. This is an informational message; no recovery is required.
710
Cause. An RDF process tried to obtain audit trail information from the TMF
management process pair (TMP) on the primary system, but the TMP was not
accessible. The probable cause is that TMF is not currently running. RDF requires
that TMF be up and running on the primary and all backup nodes.
Effect. The RDF process abends.
Recovery. Start TMF on the affected node.
711
error#
is the file-system error number that identifies the specific error.
Internal error detected
Logfile opened or altered filename
TMP is inaccessible
Failure to get process info - error error#