RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-7
RDF Messages
Cause. The updater failed to obtain process information about itself. This is a fatal
error.
Effect. The updater process abends.
Recovery. This is an internal error. Contact your service provider.
712
nnn nnn
are the upper and lower bytes, respectively, of the status code reported by the
NEWPROCESS procedure.
filename
is the name of the program file that was to be executed.
Cause. The monitor encountered an error while attempting to create an RDF process.
The error fields reported in the message are the upper and lower bytes of the status
returned by the NEWPROCESS system procedure followed by the file-name of the
program that was to be run.
Effect. The process is not started, and RDF shuts down.
Recovery. Consult the description of the NEWPROCESS procedure errors in the
Guardian Procedure Errors and Messages Manual to determine the cause of the
failure. Once the underlying cause is corrected, RDF can be restarted.
713
nnn nnn
are the upper and lower bytes, respectively, of the status code reported by the
NEWPROCESS procedure.
filename
is the name of the program file that was to be executed.
Cause. The primary process of an RDF process pair encountered an error while
attempting to create its backup process. The error fields reported in the message are
the upper and lower bytes of the status returned by the NEWPROCESS system
procedure followed by the file-name of the program that was to be run.
This error will occur if one or more parameters in the configuration file are incorrect, if
the required processor is not running, or if there are insufficient resources.
Process creation error nnn nnn, file filename
Backup process creation error nnn nnn, file filename