RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-8
RDF Messages
Effect. The backup process is not started. The primary continues to run, but will be
vulnerable to a CPU failure. The primary will try to create its backup repeatedly until it
succeeds.
Recovery. Consult the description of the NEWPROCESS procedure errors in the
Guardian Procedure Errors and Messages Manual to determine the cause of the
failure. Once the underlying cause is corrected, the backup process can be created.
714
error#
is the file-system error number that identifies the specific error.
Cause. A call to the checkpoint procedure failed, and the backup process of a process
pair is still running. The message includes the number of the file-system error that was
encountered when the primary process was trying to communicate with the backup
process.
Effect. The backup process is stopped, and a new one is created after about
15 seconds.
Recovery. This is an informational message; no recovery is required. However,
consult the description of the NEWPROCESS procedure errors in the Guardian
Procedure Errors and Messages Manual to determine the cause of the failure. If
possible, correct the underlying cause to avoid its reoccurrence.
715
Cause. The primary process of a NonStop process pair has stopped. This probably
was the result of an operator inadvertently issuing a STOP command from TACL.
Effect. The backup process takes over, but not in fault-tolerant mode, until the primary
process can be re-created.
Recovery. This is an informational message; no recovery is required.
716
Cause. The primary process of a process pair has abended.
Effect. The backup process takes over, but not in fault-tolerant mode, until the primary
process can be re-created.
CHECKPOINT Failure - backup comm error error#
Primary stopped
Primary abended