RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-15
RDF Messages
Recovery. This is an informational message; no recovery is required. To see if the
message resulted from an incorrect configuration file, examine the configuration file
and verify that all necessary parameters have been specified correctly. Report this
error to your service provider.
735
sno
is the sequence number in the Master Audit Trail (MAT) of the last audit record
received by the RDF receiver process.
rba
is the relative byte address of the record.
Cause. The purger logs this message after successful completion of an RDF takeover
operation.
If all data volumes on the primary system are configured to the MAT, then the reported
position is the end of the last record received from the extractor.
If any data volumes on the primary system are configured to auxiliary audit trails, then
the reported position is the end of the last commit or abort record received from the
extractor for which no data from any auxiliary audit trail is missing.
Effect. The MAT position is used for two purposes:
1. to compare MAT positions in preparation for the COPYAUDIT command of the
Triple Contingency protocol
2. to use for File Recovery to a MAT position on the primary system
Recovery. This is an informational message; no recovery is required.
736
error#
is the file-system error number that identifies the specific error.
filename
is the name of the file that caused the error.
Cause. The updater could not obtain information about the specified file. Before an
updater can apply audit records to a file, it must obtain information about the file. The
MAT position of last audit record SNO sno RBA rba
Waiting to obtain FILEINFO on file filename, error error#