RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-17
RDF Messages
739
error#
is the file-system error number that identifies the specific error.
filename
is the name of the file that the updater tried to create.
Cause. An updater was unable to create a file on its UPDATEVOLUME disk. The
message includes both the file-system error number and the name of the file the
updater attempted to create.
Effect. Consult Table 5-1 to determine the effect of this error.
Recovery. Consult Table 5-1 to determine the appropriate recovery actions.
740
volume
is the name of the volume that could not be found among those protected by RDF.
error#
is the file-system error number that identifies the specific error.
Cause. This warning message is issued when a create operation for the primary
partition of a partitioned file must map one or more of the file’s secondary partitions to a
volume that does not match any of the volumes protected by RDF on the primary node.
This message is also issued when the creation of a file with alternate keys is attempted
and the corresponding alternate key file does not match any of the volumes protected
by RDF on the primary node.
Effect. The create operation fails and is skipped.
Recovery. For partitioned files and files with alternate keys, if any partition or alternate
key file is on a volume protected by RDF, then all partitions and alternate key files must
be on volumes protected by RDF. Either the file must be redefined on the primary
node, or the other volume must be made protected by RDF. In the latter case, the
backup file must then be resynchronized with the primary file.
File creation failed. Error error# On filename
Create for unprotected RDF VOLUME Failed volume. Error error#