RDF/IMP and IMPX System Management Manual (RDF 1.4+)
Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-33
RDF Messages
790
cpu
is the CPU in which the backup process was created.
Cause. The backup process of a process pair was created in the specified processor.
Effect. The primary process will now run in fault-tolerant mode.
Recovery. This is an informational message; no recovery is required.
796
error#
is the file-system error number that identifies the specific error.
filename
is the name of the image file associated with the error.
Cause. The receiver or purger could not create the specified file due to the specified
file-system error.
Effect. This is a catastrophic error; the process abends and RDF stops.
Recovery. Correct the underlying condition, and then restart RDF.
797
error#
is the file-system error number that identifies the specific error.
filename
is the name of the image file associated with the error.
Cause. The purger process could not purge an image file that is no longer needed.
The message includes the file-system error number and the name of the image file.
Effect. This is only a warning. The purger will retry the purge operation.
Backup process created in processor cpu
Image file creation error error# on filename
Warning - Image file purge error error# on filename