RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-34
RDF Messages
Recovery. Correct the underlying condition, and the purger will purge the image file in
the next purge pass.
798
error#
is the file-system error number that identifies the specific error.
filename
is the name of the image file associated with the error.
Cause. An RDF process encountered the designated file-system error while
attempting to open the specified image file.
Effect. The process abends, and RDF stops. The exception to this is an error 12 (file
in use) issued when either the receiver or purger attempts to open the file. In that case,
the process posts a short delay and then retries the operation, and it repeats these two
steps unitl successful.
Recovery. For an error 12 associated with an image trail file, perform a FUP
LISTOPENS on the file to deteremine which process currently has the designated file
open. If the process that has the file open is not an RDF process, then stop that
process. In all other cases, restart RDF.
799
error#
is the file-system error number that identifies the specific error.
filename
is the name of the image file associated with the error.
Note. Under some circumstances, after the configured backup receiver process re-creates its
primary and switches to that primary, it continues to hold an image file open. When the
receiver no longer needs this image file and the purger tries to purge it, the purger logs RDF
error 797 accompanied by file-system error 12. Whenever this error is logged, you should
perform a FUP LISTOPENS filename operation to identify the opener of the file. If the
backup receiver process is the opener, you can manually stop that process with a TACL STOP
command; this clears the problem and the next time the receiver stops or finishes with an
image file, this file will be purged.
Image trail file open error error# on filename
Image trail file read error error# on filename, RBA rba