RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-39
RDF Messages
Recovery. Determine the cause of the error. If the receiver or purger did not abend,
correct the condition, then restart RDF.
813
Cause. This message is reported by updater processes when the number of
concurrent file opens exceeds the capacity of the table in which the updater maintains
information about file opens.
Effect. The updater will close idle files (if any) and continue. If there are no idle files,
then the updater will close all files and establish a restart point from which processing
can continue. In the latter case, there will be a performance degradation.
Recovery. This is an informational message. If the condition persists, however, your
database administrator should consider moving some of the files protected by TMF on
the primary node volume to another volume, and adding another updater to back up
the new volume. If you do that, you must synchronize the affected volumes on the
primary and backup nodes.
814
cpu#
is the number of the processor in which the backup process is now running.
Cause. The primary process has stopped for some reason, perhaps a cpu failure.
Effect. The backup process of the process pair (in the designated cpu) has taken
over.
Recovery. This is an informational message, although you should determine why the
primary process stopped and take corrective action, if necessary.
815
cpu#
is the number of the processor in which the primary process is now running.
Cause. A new primary process has been created by the backup process, and the
backup process has switched control to that primary process.
Effect. The primary process of the process pair (in the designated cpu) has taken
over.
Concurrent file opens exceed capacity
Backup process takeover in processor cpu#
Primary process takeover in processor cpu#