RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-42
RDF Messages
822
Cause. An RDF process is being shut down by the RDF monitor following the
premature loss of another RDF process.
Effect. The process stops normally.
Recovery. Scan the EMS event log to determine the original cause of the failure. It
might be possible to restart RDF.
823
%num num num num
identifies a network transaction.
Cause. This network transaction was committed in the audit trail on the primary
system after the first network transaction marked for undo. It can be kept because it
committed prior to the first network transaction marked for undo on a different node in
the RDF network. Please note, however, that this transaction could still be undone
during final checking for business consistency across all backup nodes.
Effect. None.
Recovery. This is an informational message; no recovery is required.
824
Cause. The RDF monitor was unable to find an extractor configuration record when
performing a START RDF command.
Effect. The START operation fails and RDF shuts down.
Recovery. Use the SET and ADD commands to create an extractor configuration
record and then retry the START RDF command.
825
Cause. The RDF monitor was unable to find a receiver configuration record when
executing a START RDF command.
Effect. The START operation fails and RDF shuts down.
Shutting down in response to ABORT RDF
Network transaction to be kept: %num num num num
Missing RDF extractor config record
Missing RDF receiver config record