RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-43
RDF Messages
Recovery. Use the SET and ADD commands to create a receiver configuration record
and then retry the START RDF command.
826
Cause. The RDF monitor was unable to find an updater configuration record when
performing a START RDF command.
Effect. The START operation fails and RDF shuts down.
Recovery. Use the SET and ADD commands to create one or more updater
configuration records.
827
Cause. The RDF process is not compatible with the audit format being generated by
TMF.
Effect. RDF stops.
Recovery. Restart RDF under the correct version of the operating system and/or TMF.
828
Cause. The primary process of a process pair has detected a problem in
communicating with the backup process. An earlier message will have indicated the
communications problem.
Effect. Because of the severity of the problem, the primary process attempts to stop
the backup process. If the backup process stops, the primary process then attempts to
create a new backup process.
Recovery. This is an informational message; no recovery is required.
829
Cause. This message indicates that the monitor detected an RDF takeover operation
was executed on the RDF backup system.
Effect. This is a catastrophic error and will cause RDF to abort.
Missing RDF updater config record
RDF version incompatible with TMF
Killing backup process ...
An RDF takeover operation was initiated on the backup system.