RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-45
RDF Messages
filename
is the name of the affected file.
Cause. The RDFNET process obtained the specified error while attempting to open
the specified file.
Effect. The RDFNET process restarts.
Recovery. Determine the underlying cause and take appropriate corrective action.
833
text
specifies the type of audit.
Cause. The extractor encountered an audit record that it did not recognize.
Effect. This is a fatal error; RDF shuts down.
Recovery. This message probably is the result of running on a primary node that has
had an audit trail created for a version of TMF that RDF does not support. The
message could also mean that the audit trail file was corrupted by some program other
than TMF, or that an irrecoverable system error has occurred.
In any event, you will have to reinitialize the TMF and RDF subsystems.
Save the audit trail, and report this error to your service provider.
834
reason
is a reason code.
Cause. This message is issued by the purger process if it has to terminate the current
purge pass for one of a variety of reasons. The reason codes refer to the internal
conditions that may be of use to support and development personnel.
Effect. The purger terminates the current purge pass. A new purge pass is initiated
after PURGETIME minutes.
Recovery. This is an informational event. Under normal conditions, it should be
logged infrequently. If the event appears regularly and if the purger stops purging files,
then it could be an indication of throughput problems between the extractor and
receiver processes. If this message persists, the purhger has stopped purging old
image files, and the extractor has not fallen behind, contact your service provider.
Filtered audit of unknown type, type
Purge pass terminated prematurely. Reason: reason