RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual524388-001
C-46
RDF Messages
835
csv
specifies the RDF control subvolume of the affected RDF environment.
command-text
is the text of the command that was issued.
Cause. The operator issued one of the following commands: ALTER, INITIALIZE RDF,
START RDF, START UPDATE, STOP RDF, STOP UPDATE, or TAKEOVER.
Effect. The RDF command is executed.
Recovery. This is an informational message; no recovery is required.
836
volume
is the name of the affected volume.
Cause. TMF reports that the specified data volume is not enabled. This may be the
result of an earlier failure and the volume is still recovering, or the user has disabled
the volume in TMFCOM.
Effect. The updater is unable to apply updates to this volume until the volume is
enabled. The updater retries the operation every minute until the volume is enabled.
Recovery. If the volume is recovering, the updater resumes processing once the
volume becomes enabled. If the data volume has been manually disabled, you must
enable it to allow the updater to resume operations.
837
sno
is the sequence number of the image file in use at the updater restart.
rba
is the relative byte address in the image file where the updater restart occurred.
csv command-text
volume is not enabled for transaction processing
Info - Restarting at image trail file position SNO sno RBA
rba