RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-51
RDF Messages
850
Cause. TMF was stopped during an RDF online database synchronization operation,
after the extractor had completed its phase one, part 1 processing.
Effect. The extractor completes phases one and two of its database synchronization
processing and then shuts down in response to the TMF shutdown audit record.
Recovery. This is an informational message; no recovery is required. When you
restart the RDF product, ensure that the duplicate database tables and files have been
moved to the backup system before you start the updaters.
851
Cause. The RDF product cannot support an environment where transactions involving
the RDF primary system have originated on more than 48 different nodes. The
receiver has encountered transactions that have originated on more than 48 nodes.
Effect. The receiver abends and the RDF system aborts.
Recovery. Recovery is not possible. Contact your service provider.
853
Cause. In determining what transactions need to be undone, the internal table of
transaction identifiers has become filled.
Effect. RDF aborts.
Recovery. Recovery is not possible. Contact your service provider.
854
Cause. While attempting to write the list of transactions that need to be undone to the
ZTXUNDO file, that file could not be opened.
Effect. RDF aborts.
Recovery. If the operation involves an RDF takeover, take corrective action to enable
the file to be opened and then reissue the TAKEOVER command.
TMF Shutdown during phase one of database synchronization
Too many nodes in network transactions.
Receiver TST filled
ZTXUNDO file cannot be opened