RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-60
RDF Messages
880
Cause. A takeover command was issued while a stop-update-to-time operation was in
progress.
Effect. The process abends and RDF aborts.
Recovery. You must reissue the Takeover command. That ensures the stop-update-
to-time operation is aborted and the RDF subsystem is prepared to execute the
takeover operation.
881
Cause. The named RDF process has encountered a restart condition and must abort
its current transaction.
Effect. The process aborts the transaction and restarts.
Recovery. This is an informational message. You must examine the event log to
determine why the process is restarting and if any recovery action is required.
882
Cause. The named RDF process' current transaction has been aborted by TMF and
the disk process.
Effect. The process restarts.
Recovery. This is an informational message. You must examine the event log to
determine why the process is restarting and if any recovery action is required.
883
Cause. The updater is configured to a virtual SMF disk that consists of more than 15
physical disks. This configuration is not supported by the RDF product.
Effect. The updater abends and the RDF subsystem shuts down.
Recovery. Reset your RDF configurations and/or your SMF configuration so that the
updaters are either assigned to physical volumes, or your SMF virtual disks map to 15
or fewer physical volumes.
Takeover issued during a stop-update-to-time operation.
Aborting current RDF process transaction.
RDF process transaction unilaterally aborted.
Physical volumes in pool exceed the limit of 15