RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-67
RDFCOM Messages
Cause. You must specify the PrimarySystem, BackupSystem, and
RemoteControlSubvolume for the network master of your RDF network.
Effect. The configuration command fails.
Recovery. Set the missing fields and add the record.
Cause. You tried to execute the COPYAUDIT command, but the RDF TAKEOVER
operation has not completed on the local system.
Effect. The COPYAUDIT command is aborted.
Recovery. You must execute the RDF TAKEOVER operation on both backup systems
before you can use the COPYAUDIT command of the triple contingency protocol.
error#
is the file-system error number that identifies the specific error.
volume-name
is the image trail volume on which insufficient storage exists.
Cause. During execution of a START RDF command or a VALIDATE
CONFIGURATION command, RDFCOM determined that sufficient disk storage for
image files did not exist in each secondary image trail for at least one additional image
file. As one of its validation checks during processing of these commands, RDFCOM
tries to create a temporary image file on the IMAGETRAIL volume and then attempts to
allocate all extents for it. This allocation failed for the reason indicated by the file-
system number error#.
Effect. The command fails.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for a
description of and recovery actions for the file-system error. Correct the error indicated
by error#. This might necessitate altering the IMAGETRAIL configuration parameter to
specify a new volume for the secondary image trail. Then, reenter the START RDF or
VALIDATE command.
A required attribute for a non network master is missing
A TAKEOVER operation has not completed on the local system
Allocation error error# on IMAGETRAIL volume-name