RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-69
RDFCOM Messages
Effect. The backup database becomes the database of record.
Recovery. This is an informational message; no recovery is required.
Cause. The COPYAUDIT command could not find audit that should exist in the local
image trail.
Effect. The COPYAUDIT command aborts.
Recovery. There may be no recovery for this problem. To verify that required audit is
missing from your local image trail, consult your local HP analyst.
Cause. You tried to have RDF/IMP protect a data volume associated with an auxiliary
audit trail.
Effect. The SET or ADD command fails.
Recovery. RDF/IMPX must be installed do this.
Cause. You tried to add an RDF object with an ATINDEX that does not correspond to
the audit trail number of a configured auxiliary audit trail.
Effect. The ADD command fails.
Recovery. Review and revise your RDF and TMF configurations.
Cause. You tried to add an updater with the specified ATINDEX, but there is no
receiver with that value.
Effect. The ADD command fails.
Recovery. Reenter theADD command specifying a correct ATINDEX.
Cause. No non network master NETWORK record was found when validating this network
master subsystem.
Effect. RDF does not start.
Audit is missing. Consult your HP analyst.
Aux audit support is only available with the RDF/IMPX product
Aux audit trail not found with index num
Aux RECEIVER Record does not exist for atindex num
At least one non network master NETWORK record required