RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-73
RDFCOM Messages
reenter the command that encountered the error. Otherwise, see your system
manager.
error#
is the error number that identifies the specific error.
Cause. A write error occurred during START RDF or STOP RDF command
processing.
Effect. The operation is aborted.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting process errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system
manager.
cpu:cpu
are the primary and backup CPUs, respectively.
Cause. Both the configured primary and backup CPUs were unavailable when a
START RDF command was issued.
Effect. The command fails.
Recovery. Wait until both CPUs become available, and reenter the START RDF
command. If necessary, see your system manager.
cpu:cpu
are the primary and backup CPUs, respectively.
Cause. A START RDF command failed because the specified CPUs do not exist (they
were not configured during SYSGEN).
Effect. The command fails.
Recovery. Reconfigure RDF to use other CPUs or, if you must use the specified
CPUs, see your system manager.
Couldn't WRITE startup to the started process error#
cpu:cpu CPUS are NOT available
cpu:cpu CPUS are not SYSGEN’d