RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual524388-001
C-75
RDFCOM Messages
then your data must be placed on TMF data volumes configured to the Master Audit
Trail. If your data must remain on TMF data volumes configured to auxiliary audit
trails, then you must reconfigure your RDF subsystem without lockstep protection.
You must rethink what data you want protected and whether or not it needs lockstep
protection. You may have to configure two separate RDF subsystems, protecting
lockstep data with one subsystem, and protecting the data associated with auxiliary
audit trails with the other RDF syubsystem. You cannot have lockstep protection for
data configured to auxiliary audit trails.
Cause. You tried to add a volume to the RDF configuration and use the online
database synchronization feature, but RDF/IMP or IMPX is not installed.
Effect. The ADD command fails.
Recovery. If you want to perform online database synchronization, RDF/IMP or IMPX
must be installed on both the primary and backup systems.
Cause. In response to your INITIALIZE RDF command and your confirmation to
proceed with that command’s execution, RDFCOM has found the record with the
specified TMF shutdown timestamp in the MAT and RDF is ready to be initialized at
that shutdown point. This message requests your confirmation to proceed further.
Effect. If you respond YES or Y, RDF will be initialized at the shutdown point you
specified; when RDF starts, the extractor will begin reading audit at that point in the
audit trail. If you respond NO or N, however, the subsystem will not be initialized.
Recovery. This is an informational message; no recovery is required.
Cause. You entered an INITIALIZE RDF command that attempted to initialize RDF at
a specific TMF shutdown timestamp, and received this message as a prompt for
confirmation.
Effect. If you respond YES or Y, RDFCOM searches the MAT file for a TMF shutdown
timestamp equal to the one specified. If you respond NO or N, RDF is not initialized.
Recovery. This is an informational message; no recovery is required.
Database synchronization is only available with the
NonStop(TM) RDF/IMP(X) product
Do you still wish to start at this point? [Y/N]
Do you wish to proceed? [Y/N]