RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-80
RDFCOM Messages
Recovery. Reenter the INITIALIZE RDF command, to begin the sequence of prompts
again. This time, respond properly (either YES, Y, NO, or N) to the prompt about
restoring the audit trail file.
error#
is the NEWPROCESS error number that identifies the specific error.
Cause. A NEWPROCESS error occurred during START RDF or TAKEOVER
processing.
Effect. The START RDF or TAKEOVER operation is aborted.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting process errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system
manager.
error#
is the NEWPROCESS error number that identifies the specific error.
Cause. A NEWPROCESS error occurred during START RDF or TAKEOVER
processing.
Effect. The START RDF or TAKEOVER operation is aborted.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting process errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system
manager.
Cause. An ADD EXTRACTOR command was issued when the configuration file
already contained an extractor record.
Effect. The command fails.
Recovery. No recovery is required if you want to use the existing extractor process as
configured. If you want to change any of the extractor’s configuration options,
however, enter an ALTER EXTRACTOR command that specifies those changes.
Extended Data Segment Error: error#
Extended Swap File Segment Error: error
EXTRACTOR record exists, use ALTER EXTRACTOR