RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-83
RDFCOM Messages
Cause. You tried to add a secondary image trail after RDF has been started.
However, you can only add secondary image trails after RDF has been initialized and
before it has been started for the first time following this initialization.
Effect. The command fails.
Recovery. If you must add an image trail, you must stop TMF, allow RDF to catch up
to the shutdown, and then reinitialize and reconfigure RDF.
vol-name
is the image trail volume for which the image trail does not exist.
Cause. You tried to add an updater, but have not yet added an image trail for the
updater’s volume.
Effect. The ADD command fails.
Recovery. Add the image trail. Then add the updater.
vol-name
is the image trail volume
Cause. You tried to add an updater for a particular ATINDEX, but there is no imagetrail
configuration for that value. Either you have not yet added the imagetrail or you added
it with a different ATINDEX.
Effect. The ADD command fails.
Recovery. Review and revise your RDF configuration.
Cause. You tried to add a secondary image trail, but the volume you specified for that
trail is already being used for receiver’s RDFVOLUME.
Effect. The command fails.
Imagetrails cannot be added if RDF has been started after
initialization
IMAGETRAIL for IMAGEVOLUME vol-name does not exist
IMAGETRAIL for IMAGEVOLUME vol-name does not exist or the
atindex of the IMAGEVOLUME does not match the updater’s
atindex
IMAGETRAIL is already in use by Receiver