RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-93
RDFCOM Messages
Effect. The command fails.
Recovery. Check system resource utilization. When resources become available,
reenter the command.
Cause. The RDF configuration file is invalid.
Effect. The configuration validation fails.
Recovery. Check the receiver parameter entries in the configuration file for invalid
values and correct any errors found.
Cause. The RDF configuration file is invalid.
Effect. The configuration validation fails.
Recovery. Check the updater process parameters in the configuration file for invalid
values and correct any errors found.
error#
is the file-system error number that identifies the specific error.
Cause. The COPYAUDIT command encountered the specified error in attempting to
read the remote image trail files.
Effect. The command fails.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the COPYAUDIT command. Otherwise, see your system manager.
Cause. Your current RDF configuration does not have the NetworkMaster attribute set
and you have tried to add more than one network record.
Effect. The configuration command fails.
No RECEIVER is Configured
No VOLUMEs are configured
Obtained error error# in attempting to examine remote
imagetrail files
Only one Network record is allowed for a non-network master