RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-95
RDFCOM Messages
primary
is the name of the primary node that can perform the operation.
Cause. The command can be issued only at the primary node.
Effect. The command fails.
Recovery. Enter another command.
Cause. The command is not allowed while RDF is running.
Effect. The command fails.
Recovery. Enter another command, or shut down RDF and reenter this command.
primary
is the name of the primary node that can perform the operation.
backup
is the name of the backup node that can perform the operation.
Cause. The command was issued at a third system, which is not allowed.
Effect. The command fails.
Recovery. Enter another command, or reenter this command at the specific primary or
backup node reflected by this message.
Cause. You entered an INITIALIZE RDF command that attempted to initialize RDF at
a specific TMF shutdown timestamp, and responded YES or Y to the subsequent
confirmation prompt, directing the subsystem to proceed with the initialization.
Effect. RDFCOM reads backward through the MAT in search of a TMF shutdown
record with the same timestamp you specified.
Operation can only be performed on the PRIMARYSYSTEM \primary
Operation is NOT allowed when RDF is running
Operation must be performed on the PRIMARYSYSTEM \primary or
BACKUPSYSTEM \backup
Please wait while RDF searches for the specified shutdown
timestamp