RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-96
RDFCOM Messages
Recovery. This is an informational message; no recovery is required. You can
terminate the operation at any time by pressing the BREAK (or equivalent) key.
volume
is the name of an RDF data volume.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause. The specified volume for the RDF subsystem with the specified control
subvolume is not configured to the master audit trail.
Effect. Validation fails.
Recovery. The PNETTXVOLUME must be configured to the master audit trail. You
need to reconfigure your network master and the subsystem with the specified control
subvolume.
volume
is the name of an RDF data volume.
Cause. The specified PNETTXVOLUME is not configured to a MAT based updater.
Effect. Validation fails.
Recovery. You must reconfigure your network master and possibly your local
configuration.
error#
is the file-system error number that identifies the specific error.
remote-config-file
is the name of the remote configuration file.
Cause. The COPYAUDIT command encountered the specified error while attempting
to position into the remote configuration file.
Effect. The COPYAUDIT command aborts.
PNETTXVOLUME volume for ctrl-subvol must be protected by a
MAT based-updater
PNETTXVOLUME volume is not configured to a MAT based updater
Position error error# on file remote-config-file