RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-104
RDFCOM Messages
Cause. RDFCOM detected an internal error in handling your response to the
RDFCOM prompt.
Effect. The attempted command is aborted.
Recovery. Contact the Global Customer Support Center (GCSC) or your service
provider.
Cause. In response to a prompt, you requested RDFCOM to trigger restoration of an
audit trail file. If the file has been previously dumped to tape, you must now watch the
EMS log for the TMP’s prompt to mount the appropriate tape.
Effect. The restore operation proceeds.
Recovery. When the tape-mount prompt appears in the EMS log, mount the tape.
Cause. You have attempted to add the NetSynch process to your configuration, but
your configuration is not the network master.
Effect. The configuration command fails.
Recovery. Do not add this record.
rdf-vol
is the RDFVOLUME specified in the network record of the network master.
Cause. The RDFVOLUME of the current RDF configuration does not match the value
specified in the network record of the network master.
Effect. Validation fails.
Recovery. You must reconfigure your network master and possibly your local
configuration.
RDFCOM internal error in handling prompt
RDFCOM is asking the TMP to restore the file. If the file
was previously dumped to tape, watch for the TMP to tell you
to mount the appropriate tape.
RDFNETS process only allowed for RDF network master
configuration.
RDFVOLUME in network master record is incorrect rdf-vol.